Aartee icon

  • Products
    • Hot Rolled
    • About
    • Product Range
    • Bright Bar
    • About
    • Product Range
  • Distribution
    • About
    • Product Range
  • About us
    • Corporate History
    • Environment
    • Health & Safety
    • Quality
    • Vacancies
  • Find us
  • English
    • D
    • I
    • E
    • F
  • Products
    • Hot Rolled
    • About
    • Product Range
    • Bright Bar
    • About
    • Product Range
  • Distribution
    • About
    • Product Range
  • About us
    • Corporate History
    • Environment
    • Health & Safety
    • Quality
    • Vacancies
  • Find us
  • English
    • D
    • I
    • E
    • F
Aartee Bright Bar > Products > Hot Rolled > Flats

Hot Rolled – Flats

Finish: Black as rolled


Sizes

Flats can be produced ʻover sizeʼ for bright drawing, in which case the sizes in the matrix should be read as finished bright or cold drawn sizes. Intermediate non-standard sizes are a speciality.

Shapes

Flats are typically supplied with sharp corners, but radius corner, sharp corner, radius edge, round edge or chamfered edge flats can be specially produced.

flats table
CycleProductsProducts
 MetricImperial
Every 5/6 weeks35mm to 132mm Wide
28mm to 81.5mm Thick
1 3/8” to 5 1/8” Wide
1 1/8” 3 3/16” Thick
Every 10/12 weeks
(Subject to tonnage build up)
>132mm Wide up to 80mm Max Thick
& All Widths between 20mm to 27mm Thick
> 5 1/8” Wide up to         3 1/8” Max Thick
& All Widths between 13/16” to 1 1/16” Thick
Every 6 Months
(Subject to tonnage build up) or by Special Agreement
All others not listed aboveAll others not listed above

Dimensional tolerances

Tolerances to typical national standards can be supplied as plus and minus, all plus, or all minus. Tight tolerances can be considered.

Straightness tolerances

Tolerances to typical national standards are available. ʻExtra-straightʼ options are available.

Lengths

Bars are only available in lengths, not in coils. Maximum length typically 12,000mm (39′ 0″)

Bar ends

Typically cold sheared, but large sizes may be cut with an abrasive disc. Cold sawn ends are also available

Typical steel types

Carbon, Freecutting, Semi-Freecutting, Leaded Freecutting, Low Alloy, Boron.

Bright bar steel
  • Home page
  • Terms & Policies
  • Privacy Policy
  • Terms of Use
  • Vacancies
  • Slavery And Human Trafficking
  • Site map

AARTEE BRIGHT BAR LTD

Website designed and built by DSM

We use cookies to ensure that we give you the best experience on our website. If you continue to use this site we will assume that you are happy with it.Accept